How to Use the Electronic Cigarette Vaporize

How to use the electronic cigarette vaporizer
The electronic cigarette must be charged for the first time, usually more than 4 hours. Lithium-ion battery, so the first time you use it, you need to do deep drawing and deep discharge. After fully charged, put on a new pod, which is the cigarette holder. After installation, it is reminded here that, after installing the cartridge, do not use it immediately, wait for more than 1 minute before using it. The purpose of this is to better integrate the liquid of the pod and the atomizer of the electronic cigarette, and volatilize more smoke.
The atomizers of electronic cigarettes are mainly divided into three types: finished products, RBA and dripping oil.
1. The finished product atomizer is easy to use, and the electronic atomizer can be used after refueling, and the product consistency is good. The disadvantage is that the previous finished atomizers generally have a general taste, the amount of smoke is not large, and the cost of replacing the atomizer core is high.
2. RBA, also known as oil storage atomizer. As the name suggests, the biggest feature is the oil storage. Compared with rdal, the RBA atomizer has the characteristics of better taste and larger amount of smoke, but the amount of smoke is not as large as that of rda. Because RBA coils are generally finished coils, they cannot be DIY like RDA. That is, the use of electronic atomizers cannot be used to make atomizing cores by yourself.
3. RDA, also known as drip-type atomizer. The components are base, heating wire, cotton, cap and drip tip. First of all, to play RDA, you must be able to wind the heating wire. Although after buying the RDA, there will almost always be two pre-wound heating wire coils in it. However, in order to pursue low resistance and large smoke, many players still choose to DIY by themselves. hot wire.
Installation of electronic nebulizer
After inserting the wound heating wire into the small hole, tighten the screw, and the RDA is half done. Then cut off the excess heating wire beyond the screw hole, adjust the angle of the heating wire, and try to move the coil to the middle. Then put the RDA on an ohmmeter to test the resistance and see if it works. Press and hold the fire button on the ohm tester to see if both coils heat up at the same time.
The normal heating of the electronic atomizer starts from the middle and turns red, and slowly continues to both sides. This is the most correct. If it is not this way of heating, use ceramic tweezers to slowly adjust the heating wire so that the coils are gathered together. Finally, use an appropriate amount of cotton to pass through the coil, make the excess cotton evenly, put it into the oil storage place of the base, drop an appropriate amount of oil into the cotton, let the cotton absorb enough e-liquid, and the ignition key drives the atomizer.